Annual sales volume of Sankang ceramic ozone tube exceeded 10000

As a manufacturer of China's ceramic ozone generation control, since the company's ozone tube series products are listed on the market, with excellent product quality and technical advantages, Sankang is in an advanced position in domestic production and marketing.

Sankang ozone tube is made of imported sintered high-purity ceramics, 316 stainless steel inner electrode and fastener, polytetrafluoroethylene and high-purity silicone rubber material, which has been tested for ten years. The ozone discharge unit of the company has high oxidation resistance, small amount attenuation and long service life.

At the same time, it has the following main characteristics.

1. High efficiency:

800-1000g / m2, 4-5 times higher than conventional ozone generation technology;

II. Low power consumption

High frequency corona discharge, power consumption rate 8 ~ 10kwh / kgo3

Three small volumes

Compared with the output products, the ozone unit volume of Sankang ceramics is 1 / 4-1 / 3 smaller;

IV. long service life, no corrosion

5. Non oxidation, high temperature resistance;

The products are made of imported sintered high-purity ceramics, 316 stainless steel inner electrodes and fasteners, polytetrafluoroethylene and high-purity silicone rubber.

No breakdown

The working voltage of the generator is only 10% of its breakdown voltage, with high dielectric constant and low loss;

VII efficient cooling

The outer pole air cooling and inner pole water cooling are used in the generator tube, and the attenuation rate of continuous ozone production is very low.

8. Wide voltage adaptability

50V produces ozone, 200V can reach the effective point, which is convenient for the regulation of ozone output

IX. saving gas source

High ozone concentration, effective gas source cost saving